Keysight N5222-60118 Installation Note page 35

Installation Procedure for the Upgrade
Step 26. Install the Overlay
To see an image of the front panel overlay (N5222-80014) click the Chapter 6
bookmark "Front Panel Assembly, Front Side, All Options" in the PDF Service
Guide
1. Remove the protective backing from the new front panel overlay
2. Loosely place the overlay in the recess on the lower front panel.
3. Placing two fingers at the middle, press the overlay firmly onto the frame
Step 27. Install the Front Panel Jumper Cables
Install twelve W30 front panel jumper cables (N5222-20091) - use 6 new
jumpers and reuse 6 old jumpers. To see an image of the front panel jumper
cables, click the Chapter 7 bookmark "Removing and Replacing the Front
Panel Assembly" in the PDF Service Guide
Step 28. Position the Cables and Wires to Prevent Pinching
On the top side of the PNA, carefully position the grey flex cables so they can't
be pinched between the covers and the rails.
On the bottom side of the PNA, carefully fold or push down the ribbon cables
and wires so they can't be pinched between the hardware and the outer cover.
Ribbon cables and wires must never be positioned on top of hardware.
Step 29. Reinstall the Inner Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the
PDF Service Guide
Step 30. Reinstall the Outer Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the
PDF Service Guide
Installation Note N5222-90118
1 . New parts are listed in
(N5222-80014).
while sliding your fingers in opposite directions towards the ends of the
overlay. Repeat on all areas of the overlay.
.
1
1 .
Table 1 on page 8.
1 .
35