Grandview Smart Screen User Manual page 6

Excessive motor use
The motor will switch off if the screen is used
continously for more than three minutes. Allow the
motor to cool for 30 minutes before using again.
If you do not expect to use your screen for some
time, please disconnect the power.
Protecting your Screen:
To ensure long lasting viewing enjoyment keep the
screen rolled up when not in use. Check both the
front and back surfaces before retracting into the
case to make sure it is free of dust, dirt, insects or
other foreign matter. Use a soft brush or cloth to
lightly remove any foreign particles.
Cleaning your Screen:
Use warm water with a mild detergent to remove
any marks on the surface (only dab, do not rub) or
screen casing. Immediately dry the screen with a
soft cloth or towel. Do not leave it to air dry.
Never use any solvents, chemicals or abrasive
cleaners on the screen surface as they can
permanently damage the screen surface.
Note: Warranty does not cover un-installing
or re-installing unit.
Imported and Distributed in Australia by
For more information please go to
www.grandviewscreens.com.au
Herma Technologies
Factory 4A, 6 Albert St
Preston, VIC 3072
or call 1300 730 025
Oct12 v1.5