Set And Show Commands; Set/Show Parameters - Digital Equipment VAXstation 4000/60 Condensed Service Information

3.1.2 SET and SHOW Commands

The VAXstation 4000 Model 60 and VLC SET and SHOW commands are used
to set and examine system parameters. Table 3–1 provides a description of the
parameters for the SET and SHOW commands.
Table 3–1 SET/SHOW Parameters
Parameter
BFLG
BOOT
CONFIG
DEVICE
DIAGENV
ETHER
ERROR
ESTAT (Model 60 only)
FBOOT
HALT
KBD
MEM
MOP
PSE
PSWD
SCSI
TRIGGER
Meaning
Default bootflag
Default boot device
System configuration
Ethernet and SCSI devices
information
Diagnostic environment; must
have loopback connector installed
and mode set to 2 or 3
Ethernet hardware address
Errors from the last system or
self-test
Status from the last system test
Power-up memory test flag
Halt recovery action
Keyboard language
Memory address range
MOP listener
Password enable
Password
System SCSI ID
Enable network console
SET SHOW
X X
X X
X
X
X X
X
X
X
X X
X X
X X
X
X X
X X
X
X X
X X
Using the Console 3–3