Subscribe to Our Youtube Channel
Related Manuals for Digital Equipment VAX 4000 500A
Summary of Contents for Digital Equipment VAX 4000 500A
-
Page 1: Installation Checklist
VAX 4000 Model 500A/505A/600A/700A/705A Installation Checklist Order Number: EK–492AB–IC. B01 Digital Equipment Corporation Maynard, Massachusetts... - Page 2 The software, if any, described in this document is furnished under a license and may be used or copied only in accordance with the terms of such license. No responsibility is assumed for the use or reliability of software or equipment that is not supplied by Digital Equipment Corporation or its affiliated companies.
-
Page 3: Preinstallation Requirements
1 Preinstallation Requirements Documents You Will Need To install and use your system, you need the following documents. • These manuals from the Customer Hardware Information Kit: Site Preparation Installation Operation Troubleshooting and Diagnostics • Console terminal documents found with the console terminal •... -
Page 4: Installation Procedures
2 Installation Procedures Assumptions This checklist assumes that your entire system arrived and that you are ready to unpack and place it in its appropriate location. How to Use This Checklist Use this checklist in conjunction with, not as a replacement for, your system Installation manual. - Page 5 2.1 Verify Site Preparation Is there adequate power for your system and its peripherals? (Site Preparation) If you are installing a DSSI configuration, did you make sure your site power distribution system does not have any grounding faults? (Site Preparation) Are you allowing enough space for your system? (Site Preparation) Does your site maintain the proper environmental operating conditions? (Site Preparation)
- Page 6 2.5 Install the Console Terminal Did you unpack the console terminal components? (Terminal installation guide) Did you connect all console terminal components? (Terminal installation guide) Did you turn on the console terminal and observe proper self-tests? (Terminal owner’s manual) Did you perform setup operations for the console terminal? (Terminal owner’s manual) Did you turn off the console terminal? (Installation) Did you connect the console terminal cable from the rear of the console...
- Page 7 2.7 Connect Additional Devices to the System Did you connect terminals and printers to the system? (Installation) Did you connect telephone modems to the system? (Installation) Did you connect the system to a network? (Installation) Did you connect the KZQSA internal cable, if required? (Installation) 2.8 Connect an Expander, If Required Are you installing an expander with your system? If so, begin installing the expander now.
- Page 8 3 After Installation Did you learn how to operate the system controls and mass storage devices? (Operation) Did you run the MicroVAX Diagnostic Monitor (MDM) software, if ordered? (Troubleshooting and Diagnostics) Did you start up and modify factory-installed software, if present? (VMS Factory Installed Software User Guide) Did you install the operating system software? (Software installation manual) If you installed a DSSI configuration, did you make sure that the ground...
Need help?
Do you have a question about the VAX 4000 500A and is the answer not in the manual?
Questions and answers