Table of Contents
Advertisement
This chapter introduces MT180 general and advanced settings.
General Settings
Press F1 button to enter the terminal menu.
Press F5 button to enter the General option.
There are five options available as follow.
•
Sys Info Query
•
Card Info Query
•
Add Finger
•
Modify Card PIN
•
Long Time Door
Enter the Sys Info Query option. You can get the terminal information.
There are five options described as follow.
Sys Info Query
Location
Version & SNR
Work Mode
Module Status
Card & Finger
Enter the Card Info Query option. Follow the on-screen prompt to swipe your card. The screen dis-
plays your card number, user name, user number and group number presetted in JanitorLite or MTTool.
Enter the Add Finger option. Follow the on-screen prompt to swipe your card. The screen displays an
Operation Notice. Follow the operation notice to put you finger on the fingerprint reader. Each card
allows to enroll a maximum of three fingerprints.
Enter the Modify Card PIN option. Follow the on-screen prompt to swipe your card. The screen dis-
plays "Input old PIN". Using the numeric keypad to enter your card password and then press F5 button
to confirm. The screen displays "Input new PIN". "Input again". The screen displays "Modify Card PIN
Success" upon successful modification.
12
On-Screen Setting
Displays the terminal location, #Controller 01, by default.
Displays the terminal firmware version and serial number.
Displays current operation mode, Access Mode, by default.
Displays the modules status of Flash1, Flash2, Finger, Reader1,
Reader2, Voice, and Network. If the module operates normally, the
screen displays "ok"; if not, the screen displays "error".
Displays the maximum card/ fingerprint capacity and current card/ fin-
gerprint count.
Chapter 3
Description
>OperationSel<
>>General
X Advanced
Advertisement
Table of Contents
