Raven AutoBoom XRT Series Installation Manual page 44

C 5
HAPTER
17. Connect the RIGHT PROP plug on the XRT cable to port 13A on the AutoBoom XRT valve.
18. Locate the machine's CAN connection near the top-left corner of the center rack.
FIGURE 7. CAN and PWR Connections
19. Connect the machine's CAN connector to one side of the CAN tee on the XRT Cable.
20. Reconnect the machine's harness (or CAN terminator) to the other end of the CAN tee.
21. Connect the machine's AUX POWER connector to the LOGIC POWER connector on the AutoBoom harness.
NOTE: If the machine's AUX POWER connector is connected to another harness, disconnect it and connect it
to the AUX POWER connector of the AutoBoom Harness.
22. Locate the machine's harness cable bulkhead on the center boom section, near the pressure transducers on the
sprayline.
FIGURE 8. AutoBoom Harness Cable Installed
23. Disconnect the machine's cable from the bulkhead connector.
40 AutoBoom® XRT Installation Manual for Case IH Patriot 3XX0/44X0 and Trident 5550 (MY 2017-19)