Table of Contents
Advertisement
INSTALLATION OVERVIEW
The image below shows approximate installation locations for the sensor and nodes. Depending on machine
configuration and desired performance some of the sensors and dampers may not be installed.
FIGURE 2. Example Component Locations
1. Radar Sensors
2. ABM Node
3. REM Node
4. Hydraulic Valve
5. Tilt Sensor
6. Rotary Sensor
7. Variable Damper
8. Proximity Sensor
For additional information on the component installation, refer to the:
• Rotary sensor installation instructions in "Center Rack Rotary Sensor Installation" on page 28.
• Variable damper installation instructions in "Optional Damper Installation" on page 21.
• REM node installation instructions in "Mount the AutoBoom XRT Valve" on page 15.
• ABM node installation instructions in "Autoboom ABM Node Installation" on page 35.
• Tilt sensor installation instructions in "Left and Right Tilt Sensor Installation (90' and 100' Boom Only)" on
page 32.
• Outer sensor installation information in "Mount the Boom Sensors" on page 25.
• Inner sensor installation information in "Mount the Boom Sensors" on page 25.
• Center sensor installation instructions in "Mount the Boom Sensors" on page 25.
• Proximity sensor installation instructions in "Proximity Sensor" on page 33.
016-0236-001 Rev. C
8
5
1
6
2
7
8
3, 4
5
INTRODUCTION
1
7
Advertisement
Table of Contents
