Sanyo LCD-32E30A Instruction Manual page 47

M E N U O P E RA T I O N
@
This func'tion has 3 modes, "Standby", "On" and 'Last'.
Under "Standby' mode, the LCD will come to Power-Off state afterAC OFF/ON.
Under the "On" mode. the LCD will come to Power-On state after the AC OFF/ON.
Under the "Last' mode:
lf the power is On state before the AC OFF, the LCD will come to Power-On after the AC ON.
lf the power is Off state before the AC OFF, the LCD will come lo Power-Off after the AC ON.
@
This function supports 5 channels to listen 1o music on ATV.
Note: "First 5 channels" means the (first, semnd ,lhird, fourth and fifth)
channel after TV autcsearching.
Setting is in done in the next layer by pressing > button in Dealer
Mode.
Each ilem can be selected from the assigned channels from 0 to 99.
(Selected channel needs to exist in the TV)
lf the items are set to OFF, the channel will return lo show original
picture.)
r
Fundion returns to the initial value of the Dealer mode setting.
@
The function supports the masler baud rate lo control the parameters of the system.
lf the Baud Rate is different from the control. the command won't be execuled.
Be sure to disconnect the power cord from AC outlet before deaning lhe LCD TV.
Clean your LCD TV as follows:
. Gently wipe the screen and cabinet with a dry, soft cloth.
. The screen is likely to be damaged if it is not maintained properly. Do not use hard doth or paper. Do nol use
solvents or abrasives.
C AUT ION :
Do not use benzene, thinner, or any volatile substances to clean the LCD TV. These chemicals may damage the
cabinet finish.
To ensure producl safety, protective features are provided inside the LCD TV. Please refer lo the following.
47