General Maintenance; Replacing The Printer Paper - 3M SelfCheck System 6210 Staff Manual

General Maintenance

Replacing the Printer Paper

When the printer paper runs out, use the following procedure to replace it
with a new roll of paper:
To order printer paper rolls, see "Obtaining Service and Supplies" on
page 19.
1
Shut down the SelfCheck system (see "Shutting down the 3M™
SelfCheck™ System" on page 12).
2
Open the right side panel of the SelfCheck system.
3
Slide the printer assembly out of the SelfCheck system chassis (1).
4
Locate the print head lever and move the lever from the Engaged
position to the Full Release position (2).
5
Lift the empty paper roll and roll pin out of the printer assembly (3).
6
Remove the paper roll from the roll pin (4).
7
Place a new paper roll on the roll pin (5).
8
Place the paper roll and roll pin on the printer assembly with the tag end
of the paper coming off the bottom of the paper roll (6).
9
Feed the leading end of the paper roll into the printer assembly. Be sure
the end of the paper roll is not ragged, or it will not feed properly (7).
10
Press the line feed button on the side of the printer assembly until the
paper feeds completely through the print head area of the printer (8).
11
Move the print head lever from the Full Release position to the Engaged
position (9).
12
Tear off any excess paper (10).
13
Slide the printer assembly back into the SelfCheck system chassis (11).
14
Close the side panel.
16
