Functions Called Via "Actions; Significance Of The Fields In The Display Blocks - Bosch FWA 43 Series Maintenance Instructions Manual

The fields in the display blocks has the following
significance:
Fields Legend
ID Does not have any significance in case
of KP and CPs and determines the
position in the vehicle in case of MPs:
"1" = front to the left
"2" = front to the right,
"3" = behind to the left,
"4" = behind to the right
Software Displays the included Firmware version.
Serial No. Display the serial number of the equipment.
Part No Display the EDV number of the equipment.
Fab Date Displays date of manufacture.
Version Displays the equipment version.
Radio Channel Displays the set radio channel.
PLD Displays the version of the PLD
(Programmable Logical Device).
Calib Data Displays the date of last calibration.
Tab. 5: Fields in the display blocks
i
The channel number is smaller by 1 then the number
displayed in the CCD server. Example: Radio Channel
"0" is displayed as channel "1" on the CCD server.
14.9.4

Functions called via "Actions"

Options
Reconnect
Reset Unit
Switch off the sensorheads
Clear data fields
Print Preview...
Print...
Write Sensorhead Version
Tab. 6: Options
Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 45
Legend
It is searched for the
connected equipments in
the selected interface.
The measuring box shall be
reset. This function should be
executed in case individual
sensor are not found.
Does not have function in
case of LAN interface.
Connected radio sensor
are deactivated.
Deletes all fields in
the display blocks.
Page view.
Printer
Is available only in
Service variants
Writes the content of
the field "Version" in the
EEPROM of the selected
measuring processors.
Register card "Light exposure"
CCD line and transmitter-LED must be configured
optimally for exact measurement and must match.
The parameter used for it can be displayed here and if
required can be modified.
The parameters are saved in communication processor
and in the measuring processor and is displayed in
different display blocks (compare colour scheme in
case of "Type and version info") and should be changed
only after consultation.
i
CQ = camera transverse track, CL = camera
longitudinal track):
14.9.5

Significance of the fields in the display blocks

Options
CQ0CL0
CQ1CL1
CQ2CL2
CQ3CL3
Current main level
Current left level
Current right level
CQ Toe ShutterCL Toe Shutter Exposure time of the
CQ Camber LEDCL
Camber LED
CQ Camber Shutter
CL Camber Shutter
Threshold
Tab. 7: Fields in the display blocks
i
The functions that be called via "Actions" are
identical to the tab "Type and version info".
en
Legend
Transmitter power for
level 0 (adjustment).
Transmitter power for
level 1 (short interval).
Transmitter power for level
2 (medium interval).
Transmitter power for
level 2 (big interval).
Currently used
transmitter power.
Currently used transmitter
power of the left transceiver
diode (if present).
Currently used transmitter
power of the right transceiver
diode (if present).
CCD sensor (Track).
Illumination and transmitter
time of the camber LED.
Exposure time of the
CCD sensor (camber).
Rejection threshold.
Avoiding image noise
through weak signals.
|
1 690 326 006 2008-8-25