Agilent Technologies U5309A Startup Manual page 16

Step 4: Install the Module
Front Panel LEDs
Indicator Purpose
DPU DPU status
STATUS Module status
Note: If warning or error status is observed, please try the following steps:
Power-cycle the chassis (If using a PCIe interface to external PC, observe the power sequence require-
l
ments)
If the error persists please contact Agilent technical support
l
16
Color State
Off
Green, blinking
Green
White
White, blinking
Green, blinking
Yellow, blinking
Red, blinking
Green
Meaning
DPU is not configured
Module initialization in progress
Module OK (firmware not yet loaded)
DPU firmware loaded (ready)
Firmware initialization in progress
Module initialization in progress
Warning
Error
OK (ready)
U5309A Startup Guide