Cleaning The Tool - Titan HKE heavy duty Instruction Manual

8.

Cleaning the tool

insertion slot,
cavities between the upper and lower jaws,
tensioning wheel
gripper plate.
Lubricate with fine conventional spray oil afterwards.
Tool inspection!
Perform a daily visual inspection of the outside of the unit. The early detection of
damaged parts extends the life of the unit. Replace all damaged parts immediately with
Original TITAN spare parts.
HKE–heavy duty
Soil and debris hamper the proper functioning of the tool. For this
reason the following areas should be cleaned once a week (blow
off using compressed air if possible):
For health reasons please do not use any cleaning
agents which contain solvents !
H 223HD EU 05/10
27 / 47