Adjustments; Cutter Adjustment; Distance Between The Feed Wheel And The Gripper Plate - Titan HKE heavy duty Instruction Manual

7.

Adjustments

7.1. Cutter adjustment

The cutter has been adjusted for the
respective thickness in the case of
varying strap thicknesses.
Release hexagon nut 72. Turn thread
pin 49 (set screw with flat point) by
means of a socket spanner in a clockwise
direction = less cutting depth;
counter-clockwise = greater cutting depth.
Fasten hexagon nut 72 after adjustment
has been completed.

7.2. Distance between the feed wheel and the gripper plate

The distance between the feed wheel 29
and the gripper plate 125 is adjusted to
0,2 mm .The adjusting screw 120 is
located in the rocker 520. Unscrew the
hexagon nut 121 using the 10 mm open-
jawed spanner and adjust a 0,2 mm gap at
the adjusting screw 120.
Fasten lock nut after adjustment has been
completed and fix plastic cover.
HKE–heavy duty
Note!
After adjustment there
should not be any, or very few,
signs of cutting on the lower
strap.
Note!
The feed wheel and the gripper
plate may not come into contact with
each other, otherwise both parts will
be subject to premature wear.
H 223HD EU 25/08
49
72
29
125
520
120
26 / 47