Installing A Module - Avaya 8300 Series Routine Maintenance

I/O module replacement
4. Slide the module from the chassis.
5. If you replace a module, see

Installing a module

Install a module to replace an existing module or to add new capability to your Ethernet Routing
Switch 8300. Module installation takes 3 to 5 minutes.
Voltage:
Risk of injury by electric shock Before working on this equipment, be aware of proper safety
practices and the hazards involved with electrical circuits. Use only power cords that have
a grounding path. Ensure the switch is properly grounded before powering on the unit.
Important:
You can install an Ethernet Routing Switch 8300 Series module with the power on or off. If
you install a module in the same chassis and slot where the same type of module was
previously installed, the previous configuration is maintained for the new module in that slot.
In all other cases, a module installed in the Ethernet Routing Switch 8310 or 8306 chassis
is reset to factory defaults.
56 Routine Maintenance
Installing a module on page 56.
May 2011