Pstn Configuration; Gsm Module; Setting Up The Device; Initial Settings (Onboarding) - Adesys Octalarm-Touch Manual

Adesys B.V. | Wateringen
3.4. PSTN configuration
There are 2 ways to connect the Octalarm-Touch to the PSTN:
• standalone;
• Additional telephone devices on the same PSTN line (Fax / Central Office etc.).
The PSTN line can be connected to the Octalarm-
Touch's RJ11 "Line In" connector. By doing so no
other device can interfere with the alarm device. In
case additional devices need to be connected to the
same PSTN line, it is very important that no other
device can occupy this line, when the Octalarm-
Touch has to call out an alarm message. Fax /
answering machines / central office equipment have
to be connected to the Phone (line out) connection.
When an alarm message has to be sent out, all other
PSTN devices are automatically disconnected from
the PSTN line, by switching off the relay contacts to
Line Seize capability.
Caution:
Verification of Line Seize capability should be made immediately after installation, and periodically
thereafter, in order to ensure that this equipment can initiate a call even when other equipment
(telephone, answering system, computer modem, etc.) connected to the same line is in use.
3.5.

GSM module

Maximum applicable antenna gain: +8dBi
4.

Setting up the device

4.1.

Initial settings (onboarding)

When you turn on the device for the first time, or after restoring the factory settings, follow the on-screen
instructions to set up your device:
1. Select the desired device language for:
• Text that is displayed on the device.
• Spoken alarm text.
See chapter "7.2.1. System language" for further information.
2. Select a region and country:
• The location you select determines the time
zone.;
See chapter "7.2.2. Time zone" for further information.
3. Select the desired keyboard.
See chapter "7.2.3. Keyboard" for further information.
4. Set the country code and any dial-out number
and/or lead digits.
See chapter "7.4.3. Country codes" for further information.
5. Change the default Octalarm name to a name that
can be used to distinguish the location.
See chapter "7.3.1. Location name" for further information.
6. Set the installer or administrator of the device:
• Complete all fields and follow the on-screen
instructions.
See chapter "5.1. Add and edit" under Contacts for further
information on the different contact roles.
Manual Octalarm-Touch | Back to
Connection for antenna (SMA female).
index
To use the GSM module, place a SIM-card in the GSM
module and slide the module into place.
The SIM card is placed on the bottom of the GSM
module. The module can then be pushed into the
GSM compartment until it clicks.
Page 6