Download Print this page

Advertisement

Quick Links

ILH SIDEI
Toole Required
- T•Nut
Dia 38mm Foot
I
OOCMNMI0
012-01-026
---4�
_..,,
Quick fix pin
C8m15N
012-o1-o89
111-41M21
Quantity: 10
Quantity: 10
DHBC
DESK HIGH BOOKCASE
SHELF
IBAS E I
Tlluepln
011-01-014
't@
Quantity: 8
4
ij
Tltuabung
011-01-013
Quantity : &
01 JUNE08
IRHSIDEI
Conflnnat acrew 50
111-22-087
PAGE01

Advertisement

loading
Need help?

Need help?

Do you have a question about the DHBC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for dams DHBC

  • Page 1 01 JUNE08 DHBC DESK HIGH BOOKCASE IRHSIDEI SHELF ILH SIDEI IBAS E I - T•Nut Toole Required Dia 38mm Foot Conflnnat acrew 50 Tlluepln OOCMNMI0 012-01-026 111-22-087 011-01-014 Quantity: 8 ---4� _..,, Quick fix pin C8m15N Tltuabung 012-o1-o89 011-01-013 111-41M21 �...
  • Page 5 DPDHD 22.01.2018 Desk High Door Pack...
  • Page 6 PHILLIPS ( PH2 ) OR POZI ( PZ2 ) SCREWDRIVER 1,2,3...
  • Page 7 Please check that you have all the panels! RM-DOR066 RM-DOR067 LH DOOR PANEL RH DOOR PANEL Please check that you have all the fittings! 110' Clip On - Soft Close Hinge Door Lock M4x22mm Handle Screw RM-HGE011 RM-LOK11 RM-SCR25 Clip On Hinge Plate Door Latch 3.5x15mm Wood Screw RM-HGP011...
  • Page 8 Diagram 1 Step 3 Attach the hinge plates to the pre drilled holes on the inside face of the bookcase side panels, these plates are fitted with pre attached screws. Ensure the plate is fitted as per diagram 1. Ensure the hook of the hinge locates into the hinge plate.
  • Page 9 Step 6 Insert the lock into the back face of the RH door, the rosette should be place over the exposed lock barrel on the front face of the door. Align the lock with the edge of the door as shown in diagram 4. Fix the lock in place using two of the 4x20mm wood screws.
  • Page 10 DOOR ADJUSMENT AND ALIGNMENT SIDE ADJUSTMENT HEIGHT ADJUSTMENT DEPTH ADJUSTMENT DOOR RELEASE BUTTON TO ADJUST THE GAP BETWEEN DOORS TO RE ALIGN SKEWED DOORS Apply equal adjustment to point A on all hinges. Adjust point A on individual hinges to re align accordingly. Tighten to make the gap smaller.

This manual is also suitable for:

Dpdhd