Supplementary Notes; Original Accessories/Auxiliary Equipment - Parkside PTS 500 B2 Translation Of The Original Instructions

Plunge saw

page of 112

/ 112
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

e) Do not use a toothed or chain saw blade or

segmented diamond-coated disc with more

than 10 mm wide slits. Such accessory tools

cause a kickback or loss of control over the

power tool.

f) Avoid cutting disc jams or excessive contact

pressure. Do not make any excessively deep

cuts. Overloading the cutting disc increases the

stress and likelihood of tilting or jamming and

thus the possibility of kickback or breakage of

the grinding tool.

g) If the cutting disc jams or you stop working,

switch the tool oﬀ and hold it steady until the

disc has completely stopped turning. Never

attempt to pull a rotating cutting disc out of a

cut. This could lead to kickback. Identify and

remove the cause of the jam.

h) Do not switch the power tool back on as long

as it is in the workpiece. Allow the cutting disc

to reach its full speed before you carefully

continue the cut. Otherwise, the disc may jam,

jump out of the workpiece or cause kickback.

i) Support panels or large workpieces to

reduce the risk of the cutting disc jamming

and causing a kickback. Large workpieces can

bend under their own weight. The workpiece

must be deposited on both sides of the disc,

namely in the vicinity of the cutting disc and

also at the edge.

j) Be particularly careful when making "pocket

cuts" into existing walls or other obscured

areas. The protruding cutting disc may cut gas

or water pipes, electrical wiring or other objects

that can cause kickback.