Operating Instructions; Boarding The Watercraft - Sea-doo SAR 2018 Series Operator's Manual

OPERATING INSTRUCTIONS

WARNING
Always perform the
SPECTION
before operating this
watercraft. Be sure to read the
SAFETY INFORMATION
WATERCRAFT INFORMATION
tions and be thoroughly familiar
with the iControl technology.
Should any control or instruction not be
fully understood, refer to an authorized
Sea-Doo dealer.

Boarding the Watercraft

As with any watercraft, boarding
should be done carefully and engine
must not be running.
WARNING
Engine must be OFF and tether
cord must be removed when
boarding the watercraft or when
using the boarding step. Never
use propulsion system compo-
nents as a supporting point to
board the watercraft.
Boarding from a Dock
When boarding from a dock, slowly
place one foot on the watercraft foot-
board (or sponson running board when
equipped with) nearest the dock while
holding the handlebar, and at the same
time, transfer the body weight to the
other side in order to balance the wa-
tercraft.
Then bring the other foot over the seat
and place it on the footboard farthest
of the dock. Push the watercraft away
from the dock.
PRE-RIDE IN-
and the
sec-
_______________
F18A01Y
TYPICAL
Boarding from Water
The ideal water depth to board the
watercraft is 90 cm (3 ft). Take into ac-
count that the hull will be lower in the
water when all passengers are aboard.
F18L0XY
TYPICAL
A. Ideal water depth = 90 cm (3 ft)
If the watercraft must be board in shal-
lower water, special care must be
taken to avoid debris from clogging
the intake grate or the cooling system
and causing premature wear or dam-
age to the propulsion system.
A
63