Fisher & Paykel WM1490F Installation Instructions Manual page 7

RMC TVA 75HFS
Adjustable between 35°C – 55°C
RMC TVA 50HP
For instantaneous gas hot water supply
Water Supply Requirements:
• Inlet water pressure: Maximum 1MPa (150psi), Minimum 30kPa (4.5psi)
• Inlet water flow rate: Minimum 6 litres/minute
Cold Supply Only:
If you only have a cold water supply, the inlet valve cap (blanking cap) which came with your washer must be connected
to the hot inlet valve. The cap prevents water leaking out of the hot valve. This appliance incorporates backflow
protection complying with AS3500.1. No further backflow protection is required for connection to the water supply.
Your washer has an internal heater to heat water. If you do not connect a hot water inlet hose, your
washer will automatically recognise there is no hot water supply and its internal heater will heat the
cold water to the selected cycle temperature.
Draining
https://producthelp.fisherpaykel.com/eu/Wash/Front_Loaders/WashSmart/WM1480P1/User_Guide_WM1480P1/03_Installatio...
Updated: Wed, 12 Feb 2020 12:46:42 GMT
Powered by
7