Memory:table:gain[:Magnitude]; Table 13-1 Frequency And Offset Factor List - Keysight Technologies U2040 X-Series Programming Manual

13 MEMory Subsystem

MEMory:TABLe:GAIN[:MAGNitude]

Syntax
MEMory:TABLe:GAIN[:MAGNitude] <numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]?
Description
This command is used to enter offsets into the frequency-dependent offset table, currently
selected using MEMory:TABLe:SELect. Any previous offset list is cleared before the new
offsets are stored.
A maximum of 512 parameters for frequency-dependent offset tables can be sent with this
command.
Entries in the frequency lists correspond (as shown in Table 13-1) with entries in the offset
factor lists.
The query returns a list of offset points for the currently selected table.
Table 13-1
Parameter
Item
numeric_value
Example
MEM:TABL:SEL "Table_1"
MEM:TABL:GAIN 97,99.5,97.4
182
Frequency and offset factor list
Frequency
Frequency 1
"
Frequency 512
Range of values
1.0 to 150.0
Offset
Offset 1
"
Offset 512
Description/Default value
A numeric value for the offset factors. The unit is PCT.
Enters offset factors of 97%, 99.5%, and
97.4% into the frequency-dependent offset
table.
Keysight U2040 X-Series Programming Guide