Milk Circuit Cleaning Cycle - LaCimbali Q10 New Touch Use And Installation

Level 1
These procedures are to be performed at the end of the work
day or when the machine sends a message (see paragraph
"Customer programming – Services hour menu).
When the machine sends a message, the screen displays
"EXECUTE WASHING MILK CIRCUIT" accompanied by an
acoustic signal.
The message and signal will continue until the procedure is
performed or up until the end of the timeout (60').
Please follow these instructions for the washing process:
1
After the machine sends the message.
4
Press the key PRG (29)
following will appear on the display:
24 29
7
Place approximately 0.7
cold water in a container and add a
dose of liquid detergent (see product
instructions).
MILK CIRCUIT CLEANING CYCLE (Self version: activable only if card is enabled)
2
1
Raise the dispensing nozzle (1).
5
. The
Press the washing key (26)
message "PRESS WASH" appears, as
shown below:
PRESS WASH
Group Washing
Milk Washing
26 Soluble Washing
8
liters of
Remove the intake tube from the milk
container and immerse it in the solution
(water-detergent).
MILK IS A FOOD PRODUCT THAT REQUIRES MAXIMUM
HYGIENE! NOT PERFORMING REGULAR AND DAILY
WASHING CYCLES CAUSES OCCLUSIONS, WHICH
CAN MAKE THE CIRCUIT BREAK AND CAUSE
LEAKS.
Therefore, please scrupulously follow the washing
instructions.
3
1
Place the washing container sotto il
6
until the
is on the group washing line, or when the
MILK WASHING option is pressed directly
on the Touch Screen.
The message below will appear on the
display:
Insert milk pipe in
the container with
water and detergent
as per instructions
65
under the dispensing nozzle (1).
The washing cycle starts if the key PRG
(29) is pressed when the cursor
START WASHING