Cleaning And Maintenance - LaCimbali M21 JUNIOR Owner's Manual

Table of Contents

Advertisement

English
Cleaning the dispenser units
This procedure should be carried out at the end of the working day
on all dispenser units.
1.
Clean the underpan gasket with a brush.
2.
Fit the blank ring into the filter holder (7), and pour in the
content of a sachet or a measure of detergent powder.
3.
Mount the filter holder (7).
4.
Press the coffee dispensing knob (2) and, after a few seconds,
press the STOP (15) push button.
5.
Repeat this procedure a few times.
6.
Remove the filter holder (7), and clean the water "shower"
with a sponge.
7.
Rinse for a few seconds with running water from each
dispenser unit.
Cleaning the Filter Holders
All the filter holders should be cleaned at the end of the working day.
1.
Pour 1 litre of cold water and a dose of detergent into a suitable
receptacle.
2.
Remove the filters from the filter holders (7).
3.
Leave the filters and filter holders (7) in the solution for at least
two hours.
4.
Remove any residues with a sponge and rinse in plenty of cold
water.
5.
Refit the filters in the filter holders (7), making sure that the filter
fixing spring is in the correct position.

CAUTION
When the machine has not been used for more than
8 hours, and in any case once a day, the internal
components must be washed before use, in
accordance to the following instructions:
Supply Groups

Fasten the filter-holders (10) to the groups (without coffee)
Allow the water to flow through for approximately one minute,
pressing one of the coffee buttons repeatedly.

Cleaning and maintenance

Drip grid and tray
At the end of the working day, remove the grid from the tray (10), pull
out and clean under running water, removing any organic residue.
Drain tray
At the end of the working day, remove the tray (10), pull out and
clean under running water, removing any organic residue.
Enclosure
The panels must be cleaned with hot soapy water (not boiling) and
then rinsed with plenty of water, removing any organic residue.
Do not use abrasive cloths or substances since they could damage
the surface of the panels.
N.B.: Do not spray any liquids in the slots.
Water reservoir
Clean the water reservoir at least once a week. Remove the reservoir
and clean under running water, removing any organic residue.
Hot water
Dispense hot water repeatedly until at least 1 liter of water has
been dispensed.
Steam
Allow the steam to flow through the nozzles for approximately
one minute, using the appropriate commands.
2
1
3
English

Advertisement

Table of Contents
loading

Table of Contents