Table of Contents
Advertisement
Set Top Box
Select entertainment input. Selecting STB will open up the STB screen. Preset STB's are selected
from the dropdown and by default include the following options (may change without notice):
•
AMINO
•
LG
If your STB is not listed on the drop down menu, you must select BVE CAB from the menu and
use the CAB add-on controller (700-0425). The CAB plugs into the CSAFE cable in place of the IR
repeater. Follow the instructions in the CAB box to set up the device or refer to document 620-8684
online.
Updating the STB Firmware
1.
With unit sitting in IDLE mode, insert a USB key
with the new firmware saved as stb.hex in the
root directory of the drive.
2.
Enter the Service Menu by pressing the top left
corner, top right corner and top left corner again
in succession
3.
Enter the password as prompted. The password is
"218"
4.
Select "Tuner" then select "STB"
5.
Press the "Hold to load new firmware" button until
programming screen appears (Fig. 25).
6.
When loaded, success screen will display.
7.
Press
to exit and go back to the Home
Screen.
F
. 34
- Set Top Box Main Screen
ig
F
. 35
- Firmware Update Dialog
ig
Page 45
Hide quick links:
Advertisement
Table of Contents
