Table of Contents
Advertisement
File Location
It is important to place the files on the USB drive
in a specific location. If the files are not placed in
/images/ as shown, the image files will not
upload to the console. The total size of all images
combined cannot exceed 20 MB.
Upload Procedure
1.
With unit sitting in IDLE mode, insert the USB key with the image files into the USB port
2.
Enter the Service Menu by pressing the top left corner, top right corner and top left corner again in
succession
3.
Enter the password as prompted. The password is "218"
4.
Select "Calibration and Setup"
5.
Select "Import Images"
6.
Press and hold "Hold to Import Images" to download images.
Note: Depending on the quantity and size of the files, the uploading process may take up to a few minutes.
DO NOT unplug the USB key while the image files are uploading.
7.
If upload is completed
successfully, screen will display
message show in Fig. 23.
8.
Once completed, switch
background and/or logo drop
down to "Custom" to display
uploaded images.
9.
Press
to exit and go back
to the Home Screen.
10.
To reset images to default,
return to Import Images screen
and set drop box to
Default/None
Toggle Screen Shot
Page 42
F
ig
Factory Only
F
. 28
- File Locations
ig
. 29
- Import Successful
Hide quick links:
Advertisement
Table of Contents
