Initial Setup - Star Trac StairMaster Core Health & Fitness 15" Capacitive Touch OpenHub Owner's Manual

INITIAL SETUP

F . 1
ig
To complete the setup, follow these steps:
1. Enter the Managers Password
2. Select the Product you are setting up.
3. Once a model is selected, the screen returns to the idle mode. Treadmills will be prompted to run a calibration
at this time. (See Maintenance Mode section)
4. Re-enter the Service Menu and then enter Maintenance Mode.
5. Verify that the serial number matches the last 5 digits of the Display Serial number. If the numbers do not
match, tap the serial to open the on-screen keypad and retype the number (the serial number is printed outside
the package of your Embedded Display).
6. Verify that the displayed model in the MODEL tab matches the previously selected product.
7. Modify any customizable parameters from the default values to meet your needs.
8. Press SAVE AND EXIT. The unit will take you to the Service Menu (screen will vary depending on model).
9. Connect to Wifi (see "Connecting to WIFI" on page 32).
10. Perform a Channel Scan (see "Channel Scan Procedure" on page 42).
Page 18
After powering the unit for the first time, the com-
puter will boot up and the Select Device screen will
appear in the display. If for any reason the screen
does not appear, on the top of the touchscreen, tap
the upper left corner, then upper right, then upper
left again. Password Screen will display.
218
to gain access to the Product Selection screen.
F . 2
ig