Creating A Process Picture - Siemens SITOP PSU8200 Manual

6 Selective monitoring of 24V feeders
6.5

Creating a process picture

You need a process picture to visualize the status of the selectivity module.
The procedure is as follows:
1. Create a new process picture or open an existing one (1) in the folder of the
technological hierarchy in which the CFC plan that you edited before is located.
Fig. 6-8
2. Execute the Compile OS function so that the system creates the process
variables, the messages, and the block icon in the OS project.
3. Open the process picture using the WinCC Graphics Designer.
4. Draw the process picture as you want it to appear and position the block icons
of signal monitoring (2) and the reset command (3) at the intended locations in
the picture.
5. Save the adapted process picture and close it.
Fig. 6-9
2
3
Integration of a SITOP 24 V Power Supply in PCS 7
Entry ID: 109481908, V1.0,
1
04/2016
45