Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Genexis FiberTwist P6426
Summary of Contents for Genexis FiberTwist P6426
- Page 1 P6426 G6426 FiberTwist Series Installation Guide Wi-Fi EasyMesh supported...
- Page 2 Installation guide Remove Blind Cover or active device (if present) FiberTwist P6426/G6426 is installed on an FTU/Bracket 1. Press and hold the unlock button (on the right side of the Blind Cover or active device). Various translations of this document (if available) and additional product information can be 2.
- Page 3 Twist! 1. Take the FiberTwist P6426/G6426 out of the box. 1. Place the FiberTwist P6426/G6426 on the FTU/Bracket as shown in the picture below. 2. The dust cap is connected to the red string 2. Rotate clockwise until it clicks into place.
- Page 4 5. Toggle the ON/OFF button on the bottom Manual pairing described in this installation guide. of the FiberTwist P6426/G6426 in the ON The WiFi network name and WiFi key position to turn on the device. are printed on the labels of the 1.
-
Page 5: Led Overview
LED overview Uplink Green – optical WAN link is established Green (blinking) – optical WAN link is in progress Red (blinking) – insufficient optical input signal – no optical WAN link detected Internet (IP connectivity) Green – connected (DNS available) Green (blinking) –... -
Page 6: Button Overview
Button overview Unlock button Remove FiberTwist P6426/G6426 – press and hold while twisting counterclockwise Mode button Pairing (WPS) – press and release once WiFi ON – press and hold until WiFi LED turns solid green WiFi OFF – press and hold until WiFi LED turns off... -
Page 7: Port Overview
Port overview ON/OFF switch Telephone Reset Power port LAN ports ports TV port button Unlock button LED dim button Dim LEDs – press and release repeatedly to dim LEDs USB 2.0 port Reset button (recessed) ON/OFF switch Reboot – short press once Switch ON –... -
Page 8: Troubleshooting
EU Declaration of Conformity Is the Status LED solid red? Is the Internet LED blinking green for Hereby, Genexis Netherlands B. V . declares that the radio equipment type FiberTwist P6426/G6426 Contact your service provider. 5 minutes? is in compliance with Directive 2014/53/EU, Directive 2009/125/EC, Directive 2011/65/EU and FiberTwist P6426/G6426 does not have a Delegated Directive 2015/863. - Page 9 Revision 1.5 - April 2022 - Copyright © 2022 Genexis Netherlands B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.