Button overview Port overview LAN ports Power port Unlock button Remove FiberTwist or Blind Cover – press and hold while twisting counterclockwise Reset button (recessed) Reset – press and release LED dim button Dim LEDs – press and release to dim LEDs in steps...
LED overview System Green – system ok Green (blinking) – booting – system error Red (blinking) – insufficient optical signal – power off Uplink Green – link ok Green (blinking) – link ok, no remote management – no link...
Page 4
2. Rotate the Blind Cover counterclockwise till it blocks. Box contents Important: Instructions need 3. Remove the Blind Cover from the baseplate (FTU) by pulling • Genexis FiberTwist (active device) to be followed precisely and it towards yourself. • Power adapter uninterrupted.
Page 5
Remove dust cap Twist! 1. Take the FiberTwist out of the box. 1. Place the FiberTwist on the FTU as shown in the picture below, 2. The dust cap is connected to the red string in a 30–degree angle. located on the rear of the FiberTwist. 2.
1. If required, connect your personal devices to the LAN ports via an RJ45 network cable. Hereby, Genexis B. V . declares that the products FiberTwist-P2410 and 2. Connect the supplied power adapter to the FiberTwist and plug the adapter FiberTwist-P2411 are in compliance with Directives 2014/30/EU, 2014/35/EU, into a power socket.
Need help?
Do you have a question about the FiberTwist P2410 and is the answer not in the manual?
Questions and answers