Advertisement
(Figure #5)
(Figure #6)
(Figure #7)
Casablanca Fan Co. - Factory Service Department - Technical Library
Step #4
Once the paper clip has been inserted into the hole with
the wire (shown in Figure #5), lift up or press down on the
clip and at the same time pull out the wire removing it
from the switch as shown. Now insert the wire you just
removed from the old switch into the hole marked the
same on the New switch (shown in Figure #6). When
inserting the wire into the switch you should hear a click,
at this time pull on the wire making sure that the wire is
held tightly in the switch (shown in Figure #6). Repeat
these steps until all wires have been removed from the
old switch and inserted into the new one.
Step #5
Once all the wires have been attached on to the new
switch, push the switch back into the switch housing
cup shown in Figure #7. Screw the knurl nut back on to
the pull chain switch. Reinstall the switch housing cap
on to the fan. Now you are ready to test the fan.
Test all three (3) speeds of the fan by making sure that
you have LOW, MEDIUM AND HIGH speeds. If you
have two speeds that are the same, most likely the
wrong switch has been installed. Again look at the old
switch you removed from the fan and compare it with
the new switch.
Pull Chain Switch Replacement
VII - 7.36
- END
Advertisement
