Advertisement
(Figure #3)
(Figure #3A)
(Figure #4)
Casablanca Fan Co. - Factory Service Department - Technical Library
Step #2
Compare the old switch you are replacing and the new
one. Make sure that they are the same. Compare the
letter and numbers on the switches as shown in Fig-
ure #3.
When changing the switch you do NOT need to cut
the wires. By using a large paper clip as a tool with
both the new and old switch side by side (shown in
Figure #3A), you will be removing ONE wire from the
old switch and inserting that same wire into the new
switch. Continue to remove the wires from the old switch
until all wires have been inserted in to the new. The
most important thing in doing this, is matching the let-
ter and numbers on the back of the switches as shown
in Figure #3.
Step #3
Using the letter and number on the switch as a refer-
ence, insert the paper clip into the same hole that the
wire is in. This is easily done by placing the paper clip
along the side of the wire as shown in Figure #4 and
pushing the clip into the hole and pulling out the wire.
NOTE: It is very important when removing the wire from
the OLD switch has shown in Figure # 4 and and in-
serting the same wire into the New switch, it is done
one at a time. Make sure that the hole position mark-
ings match on the replacement switch as shown in
Figure # 3 at the top of this page.
Pull Chain Switch Replacement -
VII - 7.35
CONTINUED
Advertisement
