Advertisement
Step #4
Place your run capacitor block next to the
switch housing as shown in (figure #7). Locate
the gray wire that is on the old block that is wire
nutted to the gray wire that is in the switch
housing as shown. Remove the wire nut and
replace the gray wire it with the NOT TINTED
gray wire on the new block. Then wire nut the
two wires together as shown.
(Figure #7)
Step #5
Locate the second gray wire on the old block that
is connected to the pull chain switch as shown in
(figure #8A). Using a large paper clip as a tool as
shown in (figure #8B), remove the gray wire from
the switch and replace the wire with the gray
tinted wire on the new block. Replace the green
and brown wires that are connected to the pull
chain switch and the old block with the wires on
the new block as shown in (figure #8C). Once all
wires have been connected, reinstall both the pull
chain switch and capacitor block back into the
switch housing and test.
(Figure #8A)
(Figure #8C)
(Figure #8B)
END
Run Capacitor Replacement -
Casablanca Fan Co. - Factory Service Department - Technical Library
VII - 7.39
Advertisement
