Advertisement
Step #4
Once you have connected the pink wires of the
new reverse switch to the pink wires in the
switch housing as shown in (figure #8). Locate
both the yellow wires on the old and new switch
and then replace them and wire nut them to-
gether as you did with the pink wires as shown
in (figure #9).
Step #5
Do the same for both the white and gray wires,
until all the wires on the new reverse switch
have been reconnected to the wires in the
switch housing. Check your work; reinstall the
reverse switch back into the switch housing.
Rout the wires so that the switch housing cap
or light kit can be easily installed on to the
switch housing without pinching the wires as
shown in (figure #10). Again, check your work
and then test the fan.
(Figure #8)
(Figure #10)
(Figure #9)
END
Reverse Switch Replacement -
Casablanca Fan Co. - Factory Service Department - Technical Library
VII - 7.44
Advertisement
