Weslo W&S WLIVEX85610.1 User Manual page 11

4. Change the resistance of the pedals as
desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
5. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few minutes,
the console will turn off and the display will be reset.
USER SETTING PROGRAMS :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
13 To 16. Wait until the word PROGRAM begins
flashing. Press the ENTER button to validate.
3.Entering your datas
Users are free to edit the values in the order of
TIME, DISTANCE, CAL, AGE, and the level of
resistance in 10 intervals. The values and profiles
will be stored in the memory after setup.
To do that, once the program is selected and yo
pressed the ENTRE button, the first column will be
flashing and you'll use the UP and DOWN button
to create your profile. Press ENTER to validate,
you'll then move on the 2nd column. Do the same
as before for the 10 columns. Finally press START/
STOP button to start.
4. Change the resistance of the pedals as
desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
If the pedal do not move for a few seconds, the word
STOP will appear in the display, and the console will
pause. The console has an "auto-off" feature. If the
pedals do not move and the console buttons are not
pressed for a few minutes, the power will turn off
automatically to save the batteries.
WATT PROGRAM :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
17. Wait until the word PROGRAM begins flashing.
Press the ENTER button to validate.
3.Entering your datas
TIME will flash, press the UP and DOWN button to
select your TIME, then press the UP and DOWN
button to select your DISTANCE and WATTS. Press
the ENTER button to validate. FInally, press START/
STOP to start.
This program depends on your speed, as a
consequence, you cannot adjust your resistance
level.
10