Electrical Safety - Black+Decker Dustbuster DVJ215J Original Instructions Manual

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
Short circuit proof safety isolating transformer.
The mains supply is electrically separated from
the transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a
consequence the charger will be inoperable. The
charging base must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
The charging base is intended for indoor use
only.
Labels on appliance
The following symbols appear on this appliance along with
the date code
Read all of this manual carefully before using
the appliance
Only use with charger S010Q 14
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
3. Nozzle
4. Pull out crevice tool
5. LED charging indicator
6. Dust bowl
7. Charging base
8. Flip down brush
9. Charger
Use
Switching on and off (Fig. A)
• Press the button to turn, on the unit operates in slow
speed, low power mode, conserving the battery life.
• Press the button again, and the unit goes to a BOOST
mode.
(Original instructions)
• Pressing the button again will turn the product off.
Using the pull out crevice tool (Fig. B,C)
• Extend the crevice tool (4) as shown in figure C, until it
clicks in place.
• To retract the crevice tool (4) press the crevice tool
release button (4a) allowing it to return to its normal
position (Fig. B).
Note: The flip down brush (8) can only be utilised when the
crevice tool is in the retracted position.
Charging DVJ325BF, DVJ325BFS (Fig. D)
• Place the appliance onto the charging base (7) and plug
into the electrical outlet.
• Switch the electrical outlet on. The LED charging
indicator (B) will illuminate.
Charging DVJ215J, DVJ315J, DVJ320J,
DVJ325J (Fig. D1)
• Place the charger (9) into the charging port at the rear of
the handle (2) and plug into the electrical outlet.
• Switch the electrical outlet on. The LED charging
indicator (B) will illuminate.
Multi LED Display - DVJ325BF, DVJ325BFS
ENGLISH
7