Table of Contents
Advertisement
4. Ethernet
An Ethernet cable may be connected to the ETH connector (designated as ETH0 in some
versions of this router) on the front panel (see the figure above). By default, the Ethernet port
is configured as follows:
Connector
Purpose
ETH
LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
Configuration
1. Configuring the Device Using the Web Browser
You can access the router for status monitoring, configuration, and administration after
entering the IP address of the router into the web interface. The default router IP address is
192.168.1.1 (netmask 255.255.255.0). Configuration access is allowed for the user "root". The
default password is printed on the router's label.
protocol for secure communication over a network! For a detailed description and exam-
ples of the router configurations, see the Configuration manual.
2. Configuration Settings via WebAccess/DMP
If your router has been pre-installed with the WebAccess/DMP client, you may configure it
from WebAccess/DMP. Navigate your browser to:
If this is your first time, please register with the site. If not, please login with your username
and password. Once logged in, further assistance can be found here:
http://hub.bb-smartworx.com/Login/Help?HelpFile=hub.pdf
3. Restoring and Backing up the Router Configuration
After you reset the router, the current configuration is overwritten by the default settings.
We recommend that you back up the router configuration before resetting the device. Refer to
the Configuration manual for more information.
1
If the router's label does not contain a unique password, use the password "root".
QSG-0002-EN, January 24, 2020
1
Attention, it is necessary to use HTTPS
https://hub.bb-smartworx.com
7
SmartStart
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
Released in the Czech Republic
Advertisement
Table of Contents
