Table of Contents
Advertisement
Before handling the SIM card disconnect the router from the power supply!
3. Power
The router requires an external DC power supply. The DC voltage required is between
+10 to +60 V DC. The router has built-in protection against reverse polarity without signaling.
Connect the power supply cable to the PWR connector on the front panel of the router (see
the figure below).
4. Ethernet
An Ethernet cable may be connected to the ETH0 connector on the front panel (see the
figure above). By default, this Ethernet port is configured as follows:
Connector
Purpose
ETH0
LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
QSG-0002-EN, January 24, 2020
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
18
Released in the Czech Republic
SmartMotion
Advertisement
Table of Contents
