Appendix B. Hardware Procedures - IBM NetVista N70 Reference

Appendix B. Hardware procedures

Removing side cover/bezel to install parts
Read Safety notices, and "Handling
static-sensitive devices" on page vi before
continuing.
1. Turn off the power supply.
2. Disconnect all cables from the thin client.
3. Carefully lay the logic unit down on its side
with the power socket nearest the ground.
Depress the rear two buttons A , to release
the cover assembly lock mechanism. Lift the
cover assembly up B and off.
You are now ready to perform the
installation procedures provided in this
chapter.
4. Complete the procedure, "Reassembling the
thin client" when you are finished installing
components in the logic unit.
Reassembling the thin client
Read Safety notices, and "Handling
static-sensitive devices" on page vi before
continuing.
1. To reassemble the thin client, carefully
replace the cover assembly on top of the
logic unit.
2. Lower the cover slowly down until the latch
is engaged.
3. Perform steps 1 through 5 of the procedure,
"Connecting your hardware" on page 8.
© Copyright IBM Corp. 2001
39