IBM NetVista N70 Reference page 38

28
Table 5. POST error codes (continued)
POST Error Code
962
9XX
1162
11XX
12XX
1402
1403
14XX Not listed above. Check
printer before replacing Logic Unit
18XX
1962 Boot sequence error
24XX
46XX
FRU/Action
1. Check the BIOS Configuration/Setup Utility
Program (see "Appendix C. Using the BIOS
Configuration/Setup Utility program" on
page 43).
2. Parallel Adapter (if installed)
3. Logic Unit
1. Printer
2. Logic Unit
1. Check the BIOS Configuration/Setup Utility
Program (see "Appendix C. Using the BIOS
Configuration/Setup Utility program" on page
43).
2. Serial Adapter (if installed)
3. Logic Unit
1. Any Serial Device
2. Communication/Serial Device Cable
3. Logic Unit
1. Async Adapter
2. Any Serial Device
3. Communication/Serial Device Cable
4. Logic Unit
Information only
Information only
1. Printer (including configuration)
2. Logic Unit
1. Check the BIOS Configuration/Setup Utility
Program (see "Appendix C. Using the BIOS
Configuration/Setup Utility program" on
page 43). Verify PCI/ISA configuration settings.
2. If necessary, set ISA adapters to "Not Available" to
allow PCI adapters to properly configure.
3. Remove any suspect ISA adapters.
4. PCI Adapter
1. Check the BIOS Configuration/Setup Utility
Program (see "Appendix C. Using the BIOS
Configuration/Setup Utility program" on
page 43).
2. Logic Unit
1. Check cable connections.
2. Display
3. Logic Unit
1. Multiport/2 Adapter
2. Multiport/2 Interface Board
3. Memory Module