Advertisement
Step 1: Attach Wall Plate
Make sure the Wall Plate is oriented so that the flat side is against the wall as shown in Diagram 1. Use the Wall Plate as a template to
mark the two hole locations for the Lag Bolts (c) on the chosen stud. Drive each Lag Bolt through the Wall Plate and into the marked
holes with a Phillips screw driver until tight.
Step 2: Wire Management and Cover Installation
Make sure all wires and cables are in between the left and right edge of the Wall Plate (a) before installing the Cover (b). Press fit the
Cover onto the Wall Plate so each tab on the Cover fits into each slot on the Wall Plate as shown in Diagram 2.
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
c
b
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.12.05
Diagram 1a
Diagram 2
tab
a
slot
a
Advertisement
