IBM Storwize V7000 Unified Manual page 103

Front of rails
Figure 36. Friction rail box contents
Procedure
To install the support rails, complete the following steps.
1. If the slide rails in your rack installation kit came with shipping thumbscrews,
remove them.
2. Select an available 2U space in the rack to install the file modules. Refer to
Figure 37.
Front
Upper U
(for 2U
to secure system
system)
Lower U
Figure 37. Locate a 2U space in the lower section of the rack.
3. Each slide rail is marked with either an R (right) or an L (left). Select one of the
slide rails and pull the rear bracket all the way back. If a thumbscrew is
installed in the slide rail, remove it. Refer to Figure 38 on page 84.
Friction rail
(left)
M6 screws
Rear
Optional screw
into the rack
Pins
Chapter 5. Performing the hardware installation
Friction rail
(right)
83