Figure 44. Install the cable management support arm. It can be installed on either side (left or
right). The graphic shows the rear of the rack.
4.
Note: Make sure the arm with junctions is facing the file module.
Place the cable management arm on the support arm. Pull out both cable
management arm pins and then slide the cable management arm tabs into the
slots on both inside and outside of the slide rail. Push the tabs until they snap
into place.
Figure 45. Install the cable management arm.
5. Make sure that the support rail is located between the 2 nail head features.
Arm junctions
Chapter 5. Performing the hardware installation
87