IBM Storwize V7000 Unified Manual page 105

Figure 40. Install the rear end of the slide rails
6. Pull the slide rail forward and locate the front latch in the appropriate unit
7. Press the blue button to release the bracket. Push the front latch in all the way.
8. Repeat this procedure to install the other rail into the rack Make sure that each
Figure 41. Install the front end of the slide rails
Installing the file modules in the rack
About this task
To install each file module in the rack, follow these instructions:
1. Pull the slide rails forward 1 until they click, two times, into place. Carefully
space in front of the rack EIA rail. Adjust the length of the rail.
Make sure the latch is fully engaged. Refer to Figure 41.
front latch is fully engaged.
lift the file module and tilt it into position over the slide rails so that the rear
nail heads 2 on the device line up with the slide rails. Slide the file module
down until the rear nail heads slip into the two rear slots, and then slowly
lower the front of the file module 3 until the other nail heads slip into the
Chapter 5. Performing the hardware installation
85