Advertisement
Description of the Upgrade
Installation Procedure for the Upgrade
Step 13.Install the Bulkhead Connectors in the Test Set Front Plate
Refer to
1. From the back side of the test set front plate, insert a bulkhead connector
2. Install 1x washer and 1x nut. Hand tighten nut and ensure bulkhead
3. Repeat previous two steps for the remaining bulkhead connectors.
4. Torque nuts, on the front side of test set front plate, to 21 in-lbs.
Figure 8
Bulkhead Connectors Installation
20
Figure 8
for this procedure. New parts are listed in
into a hole in the plate.
connector hexagon nut, on the back side of test set front plate, is aligned
to the test set subpanel hexagon indent.
Table 1 on page
Installation Note N5242-90015
8.
Advertisement
