Advertisement
Description of the Upgrade
Installation Procedure for the Upgrade
Step 12.Install the LED Boards and Test Port Coupler Assemblies to
the Test Set Front Plate
1. Remove two screws from each LED board and remove the boards from the
2. Remove the 2-port test set front plate from the test set deck.
3. Follow the two instructions shown in
Figure 7
LED Board Assemblies and Test Port Coupler Assemblies Installation
Installation Note N5242-90015
2-port test set front plate of the PNA.
are listed in
Table 1 on page 8
Figure 7
of this document. New parts
of this document.
19
Advertisement
