Maintenance - U-Line TORK MATIC H-5805 Quick Start Manual

2. Pull paper out slightly so it covers roller and the
arrows below it. (See Figure 10)
3. Push paper under the roller and push the dispensing
lever twice (or more) to feed paper through the roller
and out the bottom of the dispenser. (See Figure 11)
The manual dispenser should be cleaned any time
there is heavy paper dust buildup inside the dispenser.
If paper dust is not a problem, approximately every
year is a good frequency for cleanings. The following is
recommended procedure for cleaning:
1. Open the dispenser and remove the roll of paper.
Open access door on cassette. Clear any loose
paper and dust from the feed assembly. Close the
cassette access door.
2. Clean paper dust from the inside of the dispenser.
This can be done in several ways, such as vacuuming,
blowing out with a can of compressed air (wear
safety glasses), wiping out with a damp cloth, etc.
PAGE 3 OF 12
LOADING INSTRUCTIONS CONTINUED
Figure 10
Figure 11

MAINTENANCE

4. Close dispenser and pull paper out of dispenser
using two hands to ensure a fresh sheet for initial
dispensing. Ensure refill gauge on front cover is
green. (See Figure 12)
Figure 12
STUB ROLL FEATURE
NOTE: When refill gauge on left front of
dispenser is red, the roll is running low and can
be moved to the stub roll spot in the dispenser.
1. To use the low roll as a stub roll, drop the low roll into
the bottom compartment while keeping the tail of
paper fed through the dispenser rollers.
2. Place new roll in top roll holder arms (as in loading
instructions above). Feed tail of new roll through
mechanism rollers. Engage push bar two times to
feed paper through.
3. Close cover and pull both sheets down to ensure
dispenser is feeding. Two sheets will dispense until
stub roll runs out.
3. Clean the cover with a gentle cloth and water. If
necessary, use an all-purpose cleaner that is safe
for plastics.
NOTE: It is not recommended that paper be
used to clean the surface of the dispenser.
Paper may scratch the high gloss surface.
0516 IH-5805