Technical Data; Identification Plate; Specifications - DURAVIT Combi-System L Operating Instructions Manual

Problem
"Side jet" button flashes:
1x
2 - 4x and vibrates
5x and vibrates
! Do you want to acknowledge the error message?
> Press the corresponding button for 2 sec.
The button stops blinking. The whirltub is restarted but the error message appears
again.

10. Technical Data

10.1 Identification Plate
The identification plate is on the back page of the operating instructions or in the tech-
nical area of the whirltub.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764, DIN EN 60335-2-60, IEC 60335-2-60
10.2 Specifications
Rated voltage
Frequency
Max. nominal output
Protection rating
38
Potential cause
Water level too low
Whirltub system defective.
Water too warm (> 42 °C),
whirltub system blocked.
Temperature sensor defective.
220 - 240 V ~ (AC)
76xxxxx xx x xx xx00:
76xxxxx xx x xx xx06:
see identification plate
IP X5 protected against sprayed water
(from any direction)
Solution
>
Add water until the water
level is about 5 cm above the
uppermost jet.
>
Call customer service.
>
Report number of flashing
signals.
>
Add cold water.
>
Call customer service.
>
Report number of flashing
signals.
50 Hz
60 Hz