Troubleshooting Support; Maintenance; Technical Data; Identification Plate - DURAVIT Jet Project Operating Instructions Manual

8. Troubleshooting support

CAUTION!
The whirltub may be repaired only by qualified plumbers and electricians.
Problem
Foaming
The whirlpool system runs
only briefly.
Whirl system does not
start.
Sound volume / quality
cannot be changed.

9. Maintenance

> Check the residual-current circuit-breaker regularly as described in its operating
instructions.

10. Technical Data

10.1 Identification Plate

The identification plate is on the back page of the Operating Instructions.
This product conforms to all the appropriate EU guidelines.
Potential cause
Soap or shampoo in the
bathwater.
Water level too low.
Mains switch switched off.
Mains fuse is switched off.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
Data not compatible.
Solution
>
Switch off the whirlpool
system.
>
Fill the tub with fresh
water.
>
Add water until the water
level is about 5 cm above
the uppermost nozzle.
>
Press "Jet" for a while.
>
Switch on at mains.
>
Switch on mains circuit
breaker.
>
Disconnect tub from mains.
>
Call Customer Service.
>
Check whether the audio
source supports the A2DP
protocol.
25