Technical Data; Identification Plate; Specifications - DURAVIT Air-System Operating Instructions Manual

Problem
Whirl system does not start?
Buttons do not function
properly?
Sound of motor during filling
/ after draining the tub (2nd
floor)
Sound volume / quality can-
not be changed.

8. Technical Data

8.1

Identification Plate

The identification plate is on the back page of the Operators Manual.
This product conforms to all the appropriate EU guidelines.
DIN EN 12764

8.2 Specifications

Rated voltage
Frequency
Max. rated power
Protection type
Protection class
22
Potential cause
Mains switch switched off.
Mains fuse is switched off.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
Air in button after whirl sy-
stem has been standing idle.
Residual water drain lines are
being opened / closed.
Data not compatible.
220-240 V ~ (AC)
76xxxxx xx x xx xx00:
76xxxxx xx x xx xx06:
see identification plate
IP X5
Protection against sprayed water
(from any direction)
1
Solution
>
Switch on at mains.
>
Switch on mains
circuit breaker.
>
Disconnect tub from mains.
>
Call Customer Service.
>
Press button once again.
>
Check whether the audio
source supports the A2DP
protocol.
50 Hz
60 Hz