Control Panel; Drain Cover; Troubleshooting Support; Technical Data - DURAVIT DuraSquare 760430000AS0000 Operating Instructions Manual

6.4 control panel

> Clean the control panel with a soft, damp cloth.

6.5 Drain cover

> Clean the drain cover with a soft, damp cloth.

7. Troubleshooting Support

cAUTIoN
The whirltub may be repaired only by a qualified plumber and electrician.
Problem
Foaming
Whirltub system does not
start?
Motor-related noise after
emptying the tub
Sound volume / quality can-
not be changed.

8. Technical Data

8.1 Identification plate

The identification plate is on the back page of the operating instructions or in the tech-
22
Potential cause
Soap or shampoo in the
bathwater.
Mains switch is switched off.
Mains fuse is switched off.
Ground-fault switch (RCD) or
circuit breaker has tripped.
Any remaining water has
drained from the pipes.
Data not compatible.
Solution
Switch off the whirltub system.
Fill the tub with fresh water.
Switch on at the mains.
Switch on the mains circuit
breaker.
Disconnect the tub from the
mains.
Call customer service.
Check whether the audio source
supports the A2DP protocol.