Fujitsu Halcyon Operating Manual page 10

Cleaning and Care
Cleaning the air lters
Mind that you have a periodical cleaning of the air lters to prevent
reducing the operation ef ciency of the product.
Using of clogged air lter with dust will lower the product performance,
and may cause air ow reduction or increase of operating noise.
Clean the air lters once every 2 weeks under normal use.
1.
Open the intake grille.
(Refer to a of step 1 in "Cleaning the intake grille".)
2. While holding the intake grille with your hand, pull up the handle a
of the lter in direction of the arrow and release the 2 claws b.
Then pull the lter out with gently sliding it downward c.
a
b
3. Filter holder and air cleaning lter are attached on the rear side
of the air lter. Remove them from the air lter by unlatching each
corner of the lter holder d.
d
d
4. Remove dust by using a vacuum cleaner or by washing the lter.
When you wash the lter, use neutral household detergent and
warm water.
After rinse the lter well, dry it thoroughly in a shaded place before
you reinstall it.
5.
Attach the air cleaning lter and the lter holder to each air lter.
6.
Attach the air lter by aligning both side of the lter with the front
panel, and push in the lter fully.
Notes:
Make sure that 2 claws are rmly snapped to the guide holes on the
panel.
7. Close the intake grille rmly.
(Refer to step 4 in "Cleaning the intake grille".)
Replacing the air cleaning lter
1.
Remove the air lter. (Refer to step 1, 2 in "Cleaning the air lters".)
2. Release 2 latches a of the lter holder, and turn over the holder in
direction of arrow b.
Remove the soiled air cleaning lter c.
Notes:
Air cleaning lter is attached on each air lter.
a
En-10 OPERATING MANUAL
c
a
b
d
d
a
b
c
3. Attach new or maintained air cleaning lter d to the lter holder.
New air cleaning lter can be attached to either of the right holder or
the left holder.
d
4. Latch 2 corners of the lter holder e to the air lter rmly.
e
5.
Reinstall the air lter. (Refer to step 6 in "Cleaning the air lters".)
6.
Close the intake grille rmly.
(Refer to step 4 in "Cleaning the intake grille".)
Following 2 types of air cleaning lters are used in this product.
When you replace them, purchase dedicated air cleaning lters for this
product.
APPLE-CATECHIN FILTER: UTR-FA16
With using static electricity, puri es the air by removing ne particles
or dust such as tobacco smoke or plant pollen.
• This lter is disposable. Do not wash or reuse it.
• Once you open the package, use it as soon as possible. The
cleaning effect is reduced if the lter is left the package opened.
• Replace the lter once every 3 months under normal use.
• With setting the fan speed high, the air cleaning effect increases.
ION DEODORIZATION FILTER (light blue): UTR-FA16-2
Contained super micro-ceramic particles produce negative air ions,
that is considered to have deodorizing effect, absorb and reduce
room smell.
• To maintain the deodorizing effect, clean the lter once every 3
months as follows:
1. Remove the ion deodorization lter.
2. Flush the lter with high-pressure hot water until the surface of
the lter is covered with water.
3. Wash the lter gently with diluted neutral detergent. Do not wash
it by wringing or rubbing to prevent reducing the deodorizing
effect by damage.
4. Rinse the lter well with water ow.
5. Dry the lter thoroughly in shaded place.
6. Reinstall the ion deodorization lter to the indoor unit.
• Replace the lter once every 3 years under normal use.
After extended non-use of the unit
If you have shut down the indoor unit for 1 month or more, perform the
FAN operation for half a day to dry the internal parts thoroughly before
you perform normal operation.
Additional inspection
After long period of use, accumulated dust inside the indoor unit may
reduce the product performance even if you have maintained the unit
with instructed daily care or cleaning procedures written in this manual.
In such a case, the product inspection is recommended.
For more information, consult authorized service personnel.
e
(1 sheet)
(Light blue, 1 sheet)